Most of the time, companies would spend a lot of money to purchase their lift trucks. It is vital, therefore to take good care of your equipment to protect your investment into the long run. It is a good idea to know the procedures which are carried out in the maintenance and care of this piece of machine.
By starting up the forklift and listening closely how it works is amongst the best ways to tell how good the engine is working. For instance, if there are any misses or knocks, the machine is faulty and this should raise some issues. What's more listen carefully for any squealing noise which come from the belts as these sounds will provide you with a wealth of information.
When doing maintenance, several of the main parts you will have to pay attention to include the horn, safety warning devices, the lights, the gauges and the overhead guard. Any faulty components or burnt out light bulbs must be replaced as soon as they are noticed. It is also vital to check the wiring.
The battery compartment terminals must be cleaned when the above parts have been inspected thoroughly. If the terminals are not clean, be sure to clean them properly. Each cell of the battery should be inspected so as to ensure the fill level is topped up to the regulated amount.
The next step is to drain all of the oil out of the machinery and then change the filters. The hydraulic filter, the transmission filter and the fuel filters have to be regularly replaced. Before fitting them, be sure to write the date on the new filters by utilizing a permanent marker in order to keep track.
Once the oil change has been completed and new filters have been fitted, visually inspect the drive axle from underneath the equipment. Be sure to grease the axle if there is any grease fitting. Check the engine belts for any frays or cracks. If you find any, fix the problem accordingly. Afterwards, check each and every other component of the equipment including the wheels. If any type of fault or concern is detected, be certain to address it immediately so as to make sure the machine is running at its safest and optimum levels.