Inspect a Forklift
There are more than 10,000 workplace injuries connected to forklifts occur every year, based on OSHA and HRSDC reports. A lot of these mishaps are caused by operator error. Lack of appropriate equipment check and maintenance causes many others. Forklift operation and maintenance is not just the cause of personal injuries, but also of damage to property. Forklifts can damage overhead pipes, sprinklers and building structures, and other machines when incorrectly utilized. The following daily check ups should be carried out in order to lessen the possibility of forklift accidents.
Prior to checking various fluid levels turn off the engine. Inspect these fluids: fuel, engine oil, hydraulic oil, brake fluid and coolant. The tires also have to be checked for signs of wear and tear. Check the air pressure in the tires. Check the condition of the forks. The load backrest should be attached firmly. Do a visual inspection of the top-clip retaining pin and heel. Afterward perform an inspection of the mast chains, hydraulic hoses, stops and cables. Make certain that the overhead and finger guards are firmly attached.
The LP powered forklift has propane tanks that have to be inspected for damage, rust or corrosion. The battery's electrolyte levels and charge have to be tested periodically. Seat belts need to be inspected for wear and tear. Check to make sure the owner's manual is stored on-board the forklift in a storage compartment. Check the seat belt to make certain the latches are secure. Test the hood latch to make certain that it is working as it should.
To make sure there are no unusual engine sounds, start the engine up and listen for any irregularities. If there are, investigate immediately. Check the steering controls and the accelerator. The parking break and the service break should be working correctly.
To ensure proper functioning in both forward and reverse, the drive control and tilt control should be checked. The functioning of the lowering control, the hoist and attachment control requires periodic checking. Test the lights and horn. Afterward check the defroster, wipers and heater to make sure they are working smoothly. Check every gauge to find out that it is reading within functional limits.